Introduction

If your Craig Electronics CMP773 battery is failing and needs replaced, this replacement guide will inform you of the steps to take when performing the replacement. Make sure you have the right tools before beginning this procedure.

Remove the two 3.2 mm PH000 screws near the charging port.
  • Remove the two 3.2 mm PH000 screws near the charging port.

Ajouter un commentaire

Pry the back cover from the device along the bottom edge.
  • Pry the back cover from the device along the bottom edge.

Ajouter un commentaire

  • Continue prying along the edge of the device until the back cover is free.

Ajouter un commentaire

  • Pry the battery free from the device using a plastic opening tool.

Ajouter un commentaire

  • Desolder the faulty battery wires.

Ajouter un commentaire

  • Solder the replacement battery wires to the circuit board.

Ajouter un commentaire

  • Apply adhesive between the replacement battery and the device before installation.

Ajouter un commentaire

Conclusion

Once the above steps have been successfully competed, power on the device. Enjoy your newly replaced battery.

Jacob Hampton

Membre depuis le 26/03/2018

145 Réputation

1 tutoriel rédigé

Équipe

IUPUI, Team S1-G5, Harley Spring 2018 Membre de l'équipe IUPUI, Team S1-G5, Harley Spring 2018

IUPUI-HARLEY-S18S1G5

6 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 47