Introduction

This tutorial will provide the necessary information on how to replace a power cable in the Crosley CR42.

Turn the device around until you are looking at the line-out port.
  • Turn the device around until you are looking at the line-out port.

  • With a cordless drill or Phillips #0 screwdriver, remove the ten 12-mm screws.

Ajouter un commentaire

Gently remove the back of the device. It should be connected by two wires.
  • Gently remove the back of the device. It should be connected by two wires.

Ajouter un commentaire

  • Gently remove both wires.

  • After de-threading the antenna wire, remove the back of the device and set it aside.

Ajouter un commentaire

  • Locate where the power cable connects to the device.

  • Pick up the device and locate the screw holding the small black peg to the device. Unscrew it and set the screw aside.

Ajouter un commentaire

  • With the pliers, remove the wire connectors. You may need to be forceful

  • It is wise to attach a marking in order to recognize how the wires should be reattached.

Ajouter un commentaire

  • Pull apart both groups of wires.

  • After getting your replacement power cord, make sure you recognize how the wires should reattach.

Ajouter un commentaire

  • Twist the connecting wires together.

  • Attach the twist-on wire connectors to the exposed wires.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eric Dybsetter

Membre depuis le 26/01/2014

142 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 1-38, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 1-38, Maness Winter 2014

CPSU-MANESS-W14S1G38

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 4

7 derniers jours : 24

30 derniers jours : 71

Total : 3,176