Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Flip your bike so the seat and handlebars are on the ground.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Slip the chain onto the crank and rear cog. Then insert wheel into rear drop-outs.
-
Make sure that the chain is on the correct side of the wheel.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Tighten brake strap using screwdriver and 10 mm socket wrench.
-
Hold the nut on the inside (near the spokes) with wrench as you tighten the screw with the screwdriver.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Center the wheel and pull back to tighten the chain.
-
If the bike wheel is unusable use tire levers to remove tire.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With the wheel pulled back, tighten the two axle nuts using the 15 mm socket wrench.
-
Tighten the non-drive side (side without the chain) first.
-
The wheel will angle as you tighten. Keep it centered with your hand as you finish tightening both axle nuts.
-
Use a tire pump to make sure the tire is full of air and ready to ride.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.