Aller au contenu principal

Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.

Ce dont vous avez besoin

  1. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 1, image 1 de 3 : étape 1, image 2 de 3 : étape 1, image 3 de 3
    • Turn the device upside down.

    • Remove all four rubber feet by prying them out using the metal spudger.

    • Once the rubber feet have been removed, use the Phillips #2 screwdriver to remove all four 13mm screws.

  2. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 2, image 1 de 2 : étape 2, image 2 de 2
    • Remove the base from the body of the blender.

  3. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 3, image 1 de 3 : étape 3, image 2 de 3 : étape 3, image 3 de 3
    • Remove the two 11mm screws securing the power cord using the Phillips #2 screwdriver.

    • Gently move the wire aside so that it is not in the way.

  4. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 4, image 1 de 3 : étape 4, image 2 de 3 : étape 4, image 3 de 3
    • Remove the four 13mm screws that hold the black plastic cover using the Phillips #2 screwdriver.

    • Gently remove the black cover.

    • Underneath, you will see a clear plastic cover that should be removed as well.

  5. Cette étape n’est pas traduite. Aidez à la traduire

    : étape 5, image 1 de 2 : étape 5, image 2 de 2
    • Cut the zip tie that holds the black, blue, red, and yellow wires together.

    • Take care not to cut the wires.

Ligne d'arrivée

2 autres ont terminé cette réparation.

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 4

30 derniers jours : 16

Total : 561