Ce dont vous avez besoin
-
-
-
Turn the device upside down.
-
Remove all four rubber feet by prying them out using the metal spudger.
-
Once the rubber feet have been removed, use the Phillips #2 screwdriver to remove all four 13mm screws.
Demander à FixBot
-
-
-
Remove the two 11mm screws securing the power cord using the Phillips #2 screwdriver.
-
Gently move the wire aside so that it is not in the way.
-
-
-
-
Remove the four 13mm screws that hold the black plastic cover using the Phillips #2 screwdriver.
-
Gently remove the black cover.
-
Underneath, you will see a clear plastic cover that should be removed as well.
-
-
-
Cut the zip tie that holds the black, blue, red, and yellow wires together.
-
-
-
-
-
Remove the 2 black, yellow, and red wires from circuit board by push down on the tab to release and then pull up.
-
-
-
Pinch perpendicular to the flat surface and pull out the black wire.
-
-
To reassemble your device, follow these instructions in reverse order.
Équipe
The Citadel Military College of South Carolina, Team S2-G1, Eggleston Fall 2018 Membre de l'équipe The Citadel Military College of South Carolina, Team S2-G1, Eggleston Fall 2018
CMCSC-EGGLESTON-F18S2G1
3 membres
6 tutoriels rédigés
