Aller au contenu principal

Introduction

This guide will help you with replacing the power cord if your device is not receiving power.

The replacement will require a soldering iron.

  1. Unplug the maker, remove the coffee pot, and flip upside down. Unplug the maker, remove the coffee pot, and flip upside down.
    • Unplug the maker, remove the coffee pot, and flip upside down.

  2. Remove the five 1.6mm Phillips #1 screws from the bottom panel. Remove the bottom panel.
    • Remove the five 1.6mm Phillips #1 screws from the bottom panel.

    • Remove the bottom panel.

  3. Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now

    Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now
  4. Push the power cord inward and away from the plastic protection plate. Push the power cord inward and away from the plastic protection plate.
    • Push the power cord inward and away from the plastic protection plate.

  5. Remove the two 1.4mm Phillips #0 screws from the plastic protection plate. Remove the plastic protection plate.
    • Remove the two 1.4mm Phillips #0 screws from the plastic protection plate.

    • Remove the plastic protection plate.

  6. Remove the two 1.6mm Phillips #1 screws from the heating element. Using a flathead screwdriver to remove the outer clips holding the heating unit in place. Flip the heating element up to allow access to the circuit board.
    • Remove the two 1.6mm Phillips #1 screws from the heating element.

    • Using a flathead screwdriver to remove the outer clips holding the heating unit in place.

    • Flip the heating element up to allow access to the circuit board.

  7. Pull out the circuit board and rest it on the side of the machine. Desolder the power cable from the motherboard.
    • Pull out the circuit board and rest it on the side of the machine.

    • Desolder the power cable from the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nicholas Eales

Membre depuis le 25/01/2018

233 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team S20-G4, Passmore Spring 2018 Membre de l'équipe USF Tampa, Team S20-G4, Passmore Spring 2018

USFT-PASSMORE-S18S20G4

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 10

30 derniers jours : 21

Total : 177