Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

This guide will lead you through the process of replacing a dead or dying motor in your Cuisinart Mini-Prep DLC-2A.

Pièces

Aucune pièce spécifiée.

  1. Remove the back panel using a Phillips #1 Screwdriver on the four screws that hold it in place. Remove the back panel using a Phillips #1 Screwdriver on the four screws that hold it in place.
    • Remove the back panel using a Phillips #1 Screwdriver on the four screws that hold it in place.

  2. Remove the three screws that hold the motor to the top case using a Phillips #1 screwdriver. Remove the three screws that hold the motor to the top case using a Phillips #1 screwdriver. Remove the three screws that hold the motor to the top case using a Phillips #1 screwdriver.
    • Remove the three screws that hold the motor to the top case using a Phillips #1 screwdriver.

  3. Pull out the metal piece from the casing. Pull apart the plastic casing that contains the rod. Take off the plastic gears.
    • Pull out the metal piece from the casing.

    • Pull apart the plastic casing that contains the rod.

    • Take off the plastic gears.

  4. Use the Phillips #1 screwdriver to take off the screws that hold the white plastic to the metal piece. Pull apart the white plastic from the metal piece.
    • Use the Phillips #1 screwdriver to take off the screws that hold the white plastic to the metal piece.

    • Pull apart the white plastic from the metal piece.

  5. Use an electric screwdriver with a Phillips #1 head to take off the top metal piece.
    • Use an electric screwdriver with a Phillips #1 head to take off the top metal piece.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Eduardo Torres

Membre depuis le 25/09/2017

138 Réputation

1 tutoriel rédigé

Équipe

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 15

Total : 306