Introduction

Replacing the power supply involves unplugging the white connection cord from the power supply board after the top panel is removed.

Pièces

Aucune pièce nécessaire.

Turn the DVD player off. Unplugging the DVD player while it is on may result in damage to the DVD player or an inserted CD.
  • Turn the DVD player off. Unplugging the DVD player while it is on may result in damage to the DVD player or an inserted CD.

  • Unplug the DVD player from the wall socket.

  • Locate the 15mm Phillips screws on the left side (1 screw), right side (1 screw), and back (4 screws) of the DVD Player. Use the appropriate Phillips head screwdriver to remove the six screws.

Ajouter un commentaire

Remove the top panel of the DVD Player by:
  • Remove the top panel of the DVD Player by:

    • Sliding the top panel backwards.

    • Gently lifting the back of the top panel up.

Ajouter un commentaire

  • Orient the device to locate the power supply board on the far right corner. Use needle nose pliers to pull the white connector from the power supply board.

    • The power supply board is connected directly to the power cord. This is not the same thing as the mother board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Chris Menezes

Membre depuis le 07/04/2014

626 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 6-5, Forte Spring 2014 Membre de l'équipe Cal Poly, Team 6-5, Forte Spring 2014

CPSU-FORTE-S14S6G5

5 membres

5 tutoriels rédigés

Mine had a bad 2200uf 10v capacitor… I replaced it and the player works fine.

Robert Brackett - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 18

30 derniers jours : 50

Total : 2,608