Pièces

Aucune pièce nécessaire.

Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
  • Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.

Ajouter un commentaire

Remove the back casing to expose the circuit board.
  • Remove the back casing to expose the circuit board.

Ajouter un commentaire

  • Detach the gray antenna wires by gently pulling on the side closest to the circuit board.

Ajouter un commentaire

  • Detach the speaker wire by gently pulling on the side closest to the body of the camera.

Ajouter un commentaire

  • Remove the two 4.35 mm screws on the circuit board using the Philips head PH00 screw driver.

Ajouter un commentaire

  • Detach the white plug by gently pulling on the black wires.

Ajouter un commentaire

  • Remove the circuit board to expose the camera body.

  • At the same time, you will need to feed the wires through the circuit board and out the slot in the black plate under the circuit board.

Ajouter un commentaire

  • Gently pull on the grey wire to detach the microphone from the camera body.

Ajouter un commentaire

  • Detach the microphone from the circuit board by gently pulling on the grey wire.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Stanley DeLuna-Dabrowski

Membre depuis le 21/03/2018

127 Réputation

1 tutoriel rédigé

Équipe

IUPUI, Team S4-G2, Baechle Spring 2018 Membre de l'équipe IUPUI, Team S4-G2, Baechle Spring 2018

IUPUI-BAECHLE-S18S4G2

3 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 5

30 derniers jours : 7

Total : 44