Introduction

You will not be able to access the lens without following these steps. Removing the lens does not take a lot of force since it is on a hinge and should lift out easily. However, none of the items you come in contact with leading up to the lens removal are sturdy so don't be afraid to use some force.

Flip the device and lay flat.
  • Flip the device and lay flat.

Ajouter un commentaire

Remove the four (9 mm) screws with a PH2 screwdriver.
  • Remove the four (9 mm) screws with a PH2 screwdriver.

  • Remove the two (7 mm) located with a PH2 screwdriver.

Ajouter un commentaire

  • Flip the device over and pry the top off with a plastic opening tool.

Ajouter un commentaire

  • Remove the ribbon cable connecting the motherboard to the button control board by gently pulling it from its connector.

Ajouter un commentaire

  • Remove four (6 mm) screws connecting the motherboard using a J0 screwdriver.

Ajouter un commentaire

  • Remove the two cables connected to the motherboard: black power cable and the red/black fan cable.

  • the black cable requires more force to remove than the other cables.

Ajouter un commentaire

  • Lift the black latch on the ZIF connector and remove the ribbon cable that attaches the digitizer to the motherboard.

Ajouter un commentaire

  • Raise motherboard by lifting sideways and then up to avoid the ports.

Ajouter un commentaire

  • Remove wires attaching the piezoelectric speakers to the motherboard.

Ajouter un commentaire

  • Remove the five screws securing the black plastic cover with a J0 screwdriver.

  • Lift up and out to remove.

Ajouter un commentaire

  • The lamp does not need to be removed for this step to be preformed.

Ajouter un commentaire

  • Detach the keystone adjuster from the lens housing.

  • Lens is on a hinge so it should lift off easily, if it doesn't, adjust by swaying it forward or backward.

Ajouter un commentaire

  • Remove the rubber foot and warranty sticker found underneath the device.

Ajouter un commentaire

  • Remove the two screws on the bottom of the device with a J0 screwdriver.

Ajouter un commentaire

  • Remove the focus-adjustment ring from the lens housing.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrea Espinosa

Membre depuis le 15/02/2018

406 Réputation

3 tutoriels rédigés

Équipe

USF Tampa, Team S16-G2, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S16-G2, Boczar Spring 2018

USFT-BOCZAR-S18S16G2

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 10

30 derniers jours : 27

Total : 139