Introduction

Follow the remaining steps in this guide in order to locate and replace the speakers locate on the interior bottom of the device housing. Take care not to confuse the speakers with batteries, as they look similar.

Flip the device and lay flat.
  • Flip the device and lay flat.

Ajouter un commentaire

Remove the four (9 mm) screws with a PH2 screwdriver.
  • Remove the four (9 mm) screws with a PH2 screwdriver.

  • Remove the two (7 mm) located with a PH2 screwdriver.

Ajouter un commentaire

  • Flip the device over and pry the top off with a plastic opening tool.

Ajouter un commentaire

  • Remove the ribbon cable connecting the motherboard to the button control board by gently pulling it from its connector.

Ajouter un commentaire

  • Remove four (6 mm) screws connecting the motherboard using a J0 screwdriver.

Ajouter un commentaire

  • Remove the two cables connected to the motherboard: black power cable and the red/black fan cable.

  • the black cable requires more force to remove than the other cables.

Ajouter un commentaire

  • Lift the black latch on the ZIF connector and remove the ribbon cable that attaches the digitizer to the motherboard.

Ajouter un commentaire

  • Raise motherboard by lifting sideways and then up to avoid the ports.

Ajouter un commentaire

  • Remove wires attaching the piezoelectric speakers to the motherboard.

Ajouter un commentaire

  • Remove the five screws securing the black plastic cover with a J0 screwdriver.

  • Lift up and out to remove.

Ajouter un commentaire

  • Remove the two (3 mm) screws connecting the bracket down and pull out the reflector, using a J0 Philips Head Screwdriver.

Ajouter un commentaire

  • Slide the mirror straight up to remove.

Ajouter un commentaire

  • Slide out the power source and disconnect its cables from the power jack and the light.

Ajouter un commentaire

  • Remove the screws holding down the first speaker with a J0 screwdriver.

  • Remove the screws holding down the second speaker down.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Ryan Goldin

Membre depuis le 15/02/2018

210 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team S16-G2, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S16-G2, Boczar Spring 2018

USFT-BOCZAR-S18S16G2

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 9

Total : 85