Aller au contenu principal

DeWalt D28110 Power Cord Replacement

Ce dont vous avez besoin

  1. DeWalt D28110 Power Cord Replacement, Disassembling DeWalt D28110 Back Panel Disassembly: étape 1, image 1 de 1
    • Using the T-15 screwdriver, remove the four 22-mm torx screws holding the back panel in place.

    • Unplug the grinder before any disassembly.

  2. DeWalt D28110 Power Cord Replacement: étape 2, image 1 de 1
    • Use the edge of the spudger to loosen and remove the back panel.

  3. DeWalt D28110 Power Cord Replacement: étape 3, image 1 de 1
    • Remove the single 20-mm torx screw holding the rear panel in place.

  4. DeWalt D28110 Power Cord Replacement: étape 4, image 1 de 1
    • Pull back the rear side of the back panel.

  5. DeWalt D28110 Power Cord Replacement, Power Cord: étape 5, image 1 de 3 DeWalt D28110 Power Cord Replacement, Power Cord: étape 5, image 2 de 3 DeWalt D28110 Power Cord Replacement, Power Cord: étape 5, image 3 de 3
    • Locate the red switch box.

    • Using the J-10 screwdriver, unscrew the screws and detach the wires.

    • Be sure to remember under which screw the "ground" wire (black) goes.

  6. DeWalt D28110 Power Cord Replacement: étape 6, image 1 de 1
    • Unthread the two wires from the power cord clamp.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew

Membre depuis le 01/22/15

270 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 18-6, Maness Winter 2015 Membre de l'équipe Cal Poly, Team 18-6, Maness Winter 2015

CPSU-MANESS-W15S18G6

5 membres

7 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 1,752