DeWalt DWE4011 Power Cable Replacement

Introduction

When replacing electrical components on any device careful consideration must be taken to reduce risk of shock. Be sure the cord is not plugged into a power source before proceeding with this replacement guide. If the cord is cut, this should not be an issue. Reasons you might need follow this guide include: damaged power cord, or the grinder wont turn on.

Ce dont vous avez besoin

Étape 1 Power Cord

DeWalt DWE4011 Power Cable Replacement, Power Cord: étape 1, image 1 de 1

Turn to the bottom of the device and remove the 5/8" (17mm) T15 Torx screw.

Modifier

Étape 2

Remove bottom casing by separating the end handle away from the main casing.

Modifier

Étape 3

Remove the 1/2” (13mm) Phillips #2 screw holding the power cable to the device. This will free up the metal clamp holding the cable in place.

Modifier

Étape 4

Flip the grinder over and disconnect the plastic switch mechanism from the cable housing.

Modifier

Étape 5

Pull back the yellow tab holding the housing in place using a nylon spudger. Carefully pull the housing out of the casing.

Modifier

Étape 6

Locate the terminals with the two white cables attached and disconnect both.
These cables are connected to the outer terminals; connect as such during reassembly.

Modifier

Étape 7

Remove the entirety of the cable housing from the device casing.
The two wires coming from the power cable should still be connected to electrical housing at this point.

Modifier

Étape 8

Loosen the Phillips #2 screws enough to disconnect the two wires from the power cable housing.
Removing the screw entirely is fine, but unnecessary since the screws are merely clamping down the wires' ends.

Modifier