In this guide, we will be showing you how to remove and replace the Memory Modules.


Aucune pièce nécessaire.

  • After turning the computer off, close the display and turn the computer over.

Ajouter un commentaire

After the computer base (#1) is facing up, use a Philips screwdriver to remove the two captive screws (#2) which hold the base panel (#3) down.
  • After the computer base (#1) is facing up, use a Philips screwdriver to remove the two captive screws (#2) which hold the base panel (#3) down.

  • Then, use a spudger (#4) to lift up the panel. You can also use your fingernail to lift it as well.

  • After the front has been lifted up a bit, the non-screw side of the panel will need to be slid forward a little to finish lifting out the base panel from the computer.

Ajouter un commentaire

  • You don't need to disconnect the laptop's battery if you are only replacing the back panel: only perform this step if you will be handling or replacing the electrical components of the computer.

  • Disconnect the battery cable from the system board by pulling up on the battery connector (#1).

  • Turn the computer back over and open the display to the point where you can press the power button.

  • Press and hold the power button for 4 seconds to ground the system board so that you can safely remove components such as the RAM.

Ajouter un commentaire

  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

  • Using your fingertips, carefully spread apart the securing clips on each end of the memory-module slot until the memory module pops up.

Ajouter un commentaire

  • Slide and remove the memory module from any memory-module slots that you would like to repopulate.

Ajouter un commentaire

  • Align the notch on the New memory module with the tab on the memory- module slot.

Ajouter un commentaire

  • Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place. Do this individually for each memory module that is replaced.

  • NOTE : If you do not hear the click, remove the memory module and reinstall it.

Ajouter un commentaire


To reassemble your device, screw the base panel on again.

2 autre(s) ont terminé cette réparation.

Johnathan Hammond

Membre depuis le 28/02/2018

35 317 Réputation

408 tutoriels rédigés


Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.


15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 66