Introduction

In this guide, we will show you how to remove and replace the Third Hard-Drive.

Outils

Aucun outil requis.

Pièces

Aucune pièce nécessaire.

WARNING: Before working inside your computer, read the safety  information that shipped with your computer and follow the steps in Before Working Inside Your Computer.  After working  inside your computer, follow the instructions in After Working Inside Your Computer.

Ajouter un commentaire

Remove the screws that secure the battery to the computer base.
  • Remove the screws that secure the battery to the computer base.

Ajouter un commentaire

  • Using the battery cable, lift and release the battery from the tabs on the computer base.

Ajouter un commentaire

  • Turn the computer over and open the display.

Ajouter un commentaire

  • Press and hold the power button for five seconds to ground the system board.

Ajouter un commentaire

  • Slide the NEW battery under the tabs on the computer base.

Ajouter un commentaire

  • Align the screw holes on the battery with the screw holes on the computer base.

Ajouter un commentaire

  • Replace the screws that secure the battery to the computer base.

Ajouter un commentaire

  • Connect the battery cable to the system board.

Ajouter un commentaire

  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

  • CAUTION: To avoid data loss, do not remove the hard drive while the computer is On or in Sleep state.

  • CAUTION: Hard drives are extremely fragile. Exercise care when handling the hard drive.

  • NOTE: The media bay can accommodate an optical drive, a hard drive, or a solid-state drive.

  • Remove the screws that secure the tertiary hard drive assembly to the computer base.

Ajouter un commentaire

  • Using the pull-tab, disconnect the hard-drive cable from the system board.

Ajouter un commentaire

  • Lift the hard-drive assembly off the computer base.

Ajouter un commentaire

  • Disconnect the interposer from the hard drive.

Ajouter un commentaire

  • Remove the screws that secure the hard-drive bracket to the hard drive.

Ajouter un commentaire

  • Lift the hard-drive bracket off the hard drive.

Ajouter un commentaire

  • Align the screw holes on the NEW hard-drive bracket with the screw holes on the hard drive.

Ajouter un commentaire

  • Replace the screws that secure the hard-drive bracket to the hard drive.

Ajouter un commentaire

  • Connect the interposer to the hard drive.

Ajouter un commentaire

  • Align the screw holes on the hard-drive assembly with the screw holes on the computer base.

Ajouter un commentaire

  • Replace the screws that secure the hard-drive assembly to the computer base.

Ajouter un commentaire

  • Connect the hard-drive cable to the system board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Terrence15

Membre depuis le 18/12/2017

69 301 Réputation

444 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 16

Total : 47