Introduction

In this guide, we will show you how to remove and replace the Hard Drive.

Pièces

Aucune pièce nécessaire.

WARNING: Before working inside your computer, read the safety information that shipped with your computer.
  • WARNING: Before working inside your computer, read the safety information that shipped with your computer.

  • CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

  • Lift the connector latch that secures the hard-drive cable to the connector on the system board, and then disconnect the hard-drive cable from the connector on the system board.

Ajouter un commentaire

Loosen the four captive screws that secure the hard-drive assembly to the computer base.
  • Loosen the four captive screws that secure the hard-drive assembly to the computer base.

Ajouter un commentaire

  • Using the pull-tab, lift the hard-drive assembly out of the computer base.

Ajouter un commentaire

  • Disconnect the interposer from the hard drives.

Ajouter un commentaire

  • Remove the four screws that secure the primary hard drive (HDD 0) and lift the hard drive out of the hard -drive bracket.

Ajouter un commentaire

  • Remove the four screws that secure the secondary hard drive (HDD 1) and slide the hard drive out of the hard-drive bracket.

  • CAUTION: When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge" in the safety instructions that shipped with your computer).

Ajouter un commentaire

  • Place the primary hard drive (HDD0) in the hard-drive bracket.

Ajouter un commentaire

  • If applicable, slide the secondary hard drive into the hard-drive bracket.

Ajouter un commentaire

  • Replace the four screws that secure the primary hard drive (HDD 0).

Ajouter un commentaire

  • If applicable, replace the four screws that secure the secondary hard drive (HDD 1) to the hard-drive bracket.

  • Connect the interposer to the hard drives.

Ajouter un commentaire

  • Place the hard-drive assembly in the computer base.

Ajouter un commentaire

  • Tighten the four captive screws that secure the hard-drive assembly to the computer base.

Ajouter un commentaire

  • Connect the hard-drive cable to the connector on the system board and press down on the connector latch to secure the cable.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Terrence15

Membre depuis le 18/12/2017

69 311 Réputation

444 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 8

Total : 40