Introduction

In this guide, we will show you how to remove and replace the Display Assembly.

Pièces

Aucune pièce nécessaire.

WARNING: Before working inside your computer, read the safety  information that shipped with your  computer and follow the steps in Before You Begin.
  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before You Begin.

  • Disconnect and peel off the video-card connector cable from the connectors on the system board.

Ajouter un commentaire

Pull the pull-tab to disconnect the display cable from the connector on the system board.
  • Pull the pull-tab to disconnect the display cable from the connector on the system board.

Ajouter un commentaire

  • Disconnect the LED-logo board cable from the connector on the system board.

Ajouter un commentaire

  • Close the display and turn the computer over.

  • Remove the screws that secure the display assembly on the computer base.

Ajouter un commentaire

  • Disconnect the antenna cables from the connectors on the Mini-Card.

  • Note the routing of the antenna cables, and then remove the cables from the routing guides on the computer base.

Ajouter un commentaire

  • Turn the computer over and open the display.

  • Note the routing of the display cable and LED-logo board cable, and then remove the cables from the routing guides on the palm-rest assembly.

Ajouter un commentaire

  • Remove the screws, on the display hinges, that secure the display assembly to the computer base.

Ajouter un commentaire

  • Gently slide out the antenna cables through the slot on the computer base.

Ajouter un commentaire

  • Move the display to a perpendicular position to the computer base, and then lift the display assembly off the computer.

Ajouter un commentaire

  • Place the NEW display assembly in position and replace the screws, on the display hinges, that secure the display assembly to the computer base.

Ajouter un commentaire

  • Route the display cable and LED-logo board cable through the routing guides on the palm-rest assembly.

Ajouter un commentaire

  • Connect the display cable, video-card connector cable, and LED-logo board cable to the respective connectors on the system board.

Ajouter un commentaire

  • Slide the Mini-Card antenna cables through the slot on the computer base.

Ajouter un commentaire

  • Close the display and turn the computer over.

  • Route the Mini-Card antenna cables through the routing guides on the computer base.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Terrence15

Membre depuis le 18/12/2017

69 271 Réputation

444 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 4

30 derniers jours : 23

Total : 90