Introduction

The Dell Axim X30 has 5 buttons on the front of the device below the main screen. This guide will focus on the replacement of the home button, messaging button, navigator button, contacts button, and calendar button.

  1. Remove the four rubber feet with your fingers. Remove the four rubber feet with your fingers.
    • Remove the four rubber feet with your fingers.

  2. Insert the nylon spudger into the battery cover release slot to remove the battery from the device. Insert the nylon spudger into the battery cover release slot to remove the battery from the device.
    • Insert the nylon spudger into the battery cover release slot to remove the battery from the device.

  3. Remove four 12.7mm JIS #0 screws.
    • Remove four 12.7mm JIS #0 screws.

  4. Remove the back panel with a plastic opening tool. Follow the edge of the device around the entire perimeter.
    • Remove the back panel with a plastic opening tool. Follow the edge of the device around the entire perimeter.

    • The back panel will pop off easily.

  5. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  6. Disconnect ribbon cables. You may need to use a little force to disconnect them. Disconnect red and white wired connector for speaker and motherboard battery.
    • Disconnect ribbon cables.

    • You may need to use a little force to disconnect them.

    • Disconnect red and white wired connector for speaker and motherboard battery.

  7. Remove three 12.7mm JIS #0 screws. Remove three 12.7mm JIS #0 screws.
    • Remove three 12.7mm JIS #0 screws.

  8. Carefully remove motherboard.
    • Carefully remove motherboard.

  9. Remove the two 9.6 mm screws by the speaker and green battery with a JIS #0 screwdriver.
    • Remove the two 9.6 mm screws by the speaker and green battery with a JIS #0 screwdriver.

  10. Remove black plastic board. Remove black plastic board.
    • Remove black plastic board.

  11. Remove grey and green membrane buttons. Remove grey and green membrane buttons.
    • Remove grey and green membrane buttons.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonathan Gulley

Membre depuis le 28/03/2018

181 Réputation

1 tutoriel rédigé

Équipe

IUPUI, Team S2-G5, Harley Spring 2018 Membre de l'équipe IUPUI, Team S2-G5, Harley Spring 2018

IUPUI-HARLEY-S18S2G5

3 membres

2 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 115