Introduction

Use this guide to replace the video card in your computer.

Pièces

Aucune pièce nécessaire.

  1. Locate the case cover latch on the back of the computer.
    • Locate the case cover latch on the back of the computer.

  2. Using your index finger, slide and hold the cover latch down.
    • Using your index finger, slide and hold the cover latch down.

    • While holding the latch down, place your other hand flat on the side of the case and firmly shift the side panel to the left until it disengages.

    • Grab the edge of the panel and slide it away from the case until it is removed.

    • Lay the computer flat so that you are looking down on all of the components.

    • Locate the Video Card and the screw attached to the Video Card as shown in the picture.

    • Remove the 8.9 mm screw by using a Phillips #2 screw-driver.

    • Push down on the green clip located by the bottom right corner of the video card while simultaneously pulling the card up with your other hand.

    • Pull the remainder of the card up and out of it's slot.

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

Arvind

Membre depuis le 12/10/2011

294 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 6-10, Regan Fall 2011 Membre de l'équipe Cal Poly, Team 6-10, Regan Fall 2011

CPSU-REGAN-F11S6G10

4 membres

6 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 7

30 derniers jours : 32

Total : 6,450