Introduction

In this guide, we will show you how to remove the Display Assembly.

Pièces

Aucune pièce nécessaire.

Follow the instructions in "Before Working Inside Your Computer."

Ajouter un commentaire

Remove the four M2.5 x 5-mm screws (labeled "M2.5x5") that secure the EMI shield to the system board.
  • Remove the four M2.5 x 5-mm screws (labeled "M2.5x5") that secure the EMI shield to the system board.

Ajouter un commentaire

  • Pull the EMI shield out of the computer baseby rotating the front upwards then lifting to release the retention tabs from the retention-tab slots.

Ajouter un commentaire

  • Disconnect the attached antenna cable from the Mini PCI card.

Ajouter un commentaire

  • Close the display.

  • From the bottom of the computer, remove the two M2.5 x 5-mm screws labeled "D."

Ajouter un commentaire

  • From the back of the computer, remove the two M2.5 x 8-mm screws labeled "D."

Ajouter un commentaire

  • Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.

Ajouter un commentaire

  • Carefully remove the Mini PCI card antenna cable and the display cables from their routing guides.

Ajouter un commentaire

  • Lift the display assembly out of the computer base.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Terrence15

Membre depuis le 18/12/2017

69 311 Réputation

444 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 20