Introduction

In this guide, we will be showing you how to remove and replace the Display Assembly.

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.
  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

  • Peel off the pieces of tape that secure the display cable and touch-screen board-cable to the system board.

Ajouter un commentaire

Open the latches to disconnect the display cable and the touch-screen board-cable from the system board.
  • Open the latches to disconnect the display cable and the touch-screen board-cable from the system board.

Ajouter un commentaire

  • Turn the computer over and open the display as far as possible.

  • CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.

Ajouter un commentaire

  • Place the computer face down on a flat surface.

  • Remove the screws that secure the display assembly to the palm-rest assembly.

Ajouter un commentaire

  • Lift the display assembly off the palm-rest assembly.

Ajouter un commentaire

  • Place the NEW display assembly face down on the palm-rest assembly.

Ajouter un commentaire

  • Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.

Ajouter un commentaire

  • Replace the screws that secure the display assembly to the palm-rest assembly.

Ajouter un commentaire

  • Close the display and turn the computer over.

Ajouter un commentaire

  • Slide the display cable and the touch-screen board-cable into their respective connectors on the system board and close the latches to secure the cables.

Ajouter un commentaire

  • Adhere the pieces of tape that secure the display cable and the touch-screen board-cable to their respective connectors on the system board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Terrence15

Membre depuis le 18/12/2017

69 271 Réputation

444 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 6

30 derniers jours : 34

Total : 69