Introduction

If you notice your computer screen is damaged and needs to be replaced, this guide may be able to help. This guide will show you how to replace the display screen in a few steps.

Pièces

Aucune pièce nécessaire.

WARNING :  Before working inside your computer, read the safety  information that shipped with your computer and follow the steps in  Before working inside your computer . After working inside your  computer, follow the instructions in After working inside your computer.
  • WARNING : Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer . After working inside your computer, follow the instructions in After working inside your computer.

  • Close the display and turn the computer over

Ajouter un commentaire

Remove the screws that secure the base cover to the computer base.
  • Remove the screws that secure the base cover to the computer base.

Ajouter un commentaire

  • Using a plastic scribe (plastic opening tool), pry the base cover off the computer base.

Ajouter un commentaire

  • Before opening device, ensure that all data is backed up on a hard drive to prevent data loss.

  • Loosen and then unplug the hard drive cable.

Ajouter un commentaire

  • Remove 2 M2 3mm screws, using the Phillips 1 screwdriver.

  • Remove the battery.

Ajouter un commentaire

  • Pry open the clips and remove the RAM.

Ajouter un commentaire

  • Unplug the daughter board cable in two places marked in red, then remove it.

  • Unplug the fan cable marked in orange.

Ajouter un commentaire

  • Remove 1 MR 3mm screw, using the Phillips 1 screwdriver, on the cooling fan.

  • Remove 1 M2 2mm wafer screw, using the Phillips 1 screwdriver, on the cooling fan.

  • Remove the cooling fan.

Ajouter un commentaire

  • Remove 3 M2 2mm screws, using the Phillips 0 screwdriver, on the heat sink.

  • Remove the heat sink.

Ajouter un commentaire

  • Remove the screws from the LCD cable bracket.

  • Remove the LCD cable bracket.

Ajouter un commentaire

  • Unplug the LCD cable.

  • Unplug the touchscreen cable.

Ajouter un commentaire

  • Unscrew 2 M2.5 7mm screws, using the Phillips 1 screwdriver, on the right screen hinge.

  • Unscrew 1 M2.5 7mm screw, using the Phillips 1 screwdriver, on the left screen hinge.

Ajouter un commentaire

  • Carefully undo the tape

  • Unplug the two black and white wire leads

Ajouter un commentaire

  • Carefully remove the tape that is attached to the screen by prying it off with your fingers.

  • Remove the tape outlined in red.

  • Adjust the screen so that the laptop is open flat against the surface.

  • Remove the LCD display screen by pulling it gently away from the back.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Stephany Marin Restrepo

Membre depuis le 19/03/2018

511 Réputation

5 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 15

30 derniers jours : 55

Total : 100