Introduction

This guide provides step by step instructions to remove your Dell Inspiron 13- 7359 cooling fan. You will need a phillips head #0 screwdriver and a small plastic spudger.

  1. Flip your device over so the back cover is facing you.
    • Flip your device over so the back cover is facing you.

    • Using a Phillips #0 Screwdriver, remove the ten 7mm screws holding the back cover in place.

  2. Insert a plastic opening and run it along the edge of the back cover. Do this until the entire back cover can be removed.
    • Insert a plastic opening and run it along the edge of the back cover. Do this until the entire back cover can be removed.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Unscrew and remove the 2 of the 7mm Phillips head screws holding the cooling fan in place. Unscrew and remove the 2 of the 7mm Phillips head screws holding the cooling fan in place.
    • Unscrew and remove the 2 of the 7mm Phillips head screws holding the cooling fan in place.

  5. Hold the cooling fan with one hand.
    • Hold the cooling fan with one hand.

    • With the other hand, grab hold of the part of the copper heat sink that is attached to the cooling fan.

    • Carefully pull the cooling fan away from the attached part so that it becomes fully disconnected.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Valentin Medina

Membre depuis le 30/01/2018

545 Réputation

3 tutoriels rédigés

Équipe

Baylor, Team S1-G6, Johnson Spring 2018 Membre de l'équipe Baylor, Team S1-G6, Johnson Spring 2018

BU-JOHNSON-S18S1G6

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 21

Total : 137