Introduction

Is the screen of your Inspiron 14-3452 broken? All you need is a spudger and a screwdriver in order to open up your laptop and replace its screen.

Remove the battery by sliding the battery release latch to the left.
  • Remove the battery by sliding the battery release latch to the left.

  • Pull the entire battery away from the backing.

Ajouter un commentaire

Ensure that the laptop is completely turned off and the battery is removed.
  • Ensure that the laptop is completely turned off and the battery is removed.

  • Remove the two Phillips Head 5 mm #0 screws holding the backing in place.

Ajouter un commentaire

  • Pull the backing away from the laptop.

Ajouter un commentaire

  • Locate the blue RAM chip sitting in the RAM bay.

  • Use your fingertips to pry apart the white RAM securing-clips on each side of the memory-module slot until the RAM chip pops up.

Ajouter un commentaire

  • Pull the RAM chip away from the memory-module slot.

  • The RAM chip is now fully detached and ready to be replaced.

Ajouter un commentaire

  • Remove the ten Phillips Head 5 mm #0 screws from the computer backing.

  • Remove the one Phillips Head 3 mm #0 screw from the computer backing.

Ajouter un commentaire

  • Remove the white and black antenna cables from the wireless card.

Ajouter un commentaire

  • Remove the Phillips Head 3 mm #0 screw that is holding the wireless card in place.

Ajouter un commentaire

  • Slide the wireless card out of the wireless card bay.

Ajouter un commentaire

  • Using your fingertips remove the speaker cable from the motherboard by pulling the white connector away from the socket.

Ajouter un commentaire

  • Pry apart the keyboard assembly slowly as the keyboard cable will still be attached to the motherboard.

  • Use the blue Uspudger to pry apart the keyboard assembly from the bottom shell.

Ajouter un commentaire

  • Disconnect the keyboard cable from the motherboard by lifting the black latch and pulling the cable out of its socket.

Ajouter un commentaire

  • Disconnect the display cable from the motherboard by pulling the tape back and lifting the connector latch.

  • Pull the display cable away from the motherboard.

Ajouter un commentaire

  • Remove the power adapter cable from the motherboard by sliding the cable out of its socket.

Ajouter un commentaire

  • Turn laptop over to access the screen hinge screws.

  • Remove the two Phillips Head 5 mm #0 screws from the two hinges.

Ajouter un commentaire

  • Using your fingertips, gently pry up the inner edges of the display bezel.

  • Lift the display bezel off the display assembly.

Ajouter un commentaire

  • After removing the bezel, locate the tab indicated in the pictures.

  • Lift the tab as shown in the pictures.

  • Lift the gold latch securing the display cable to the socket.

  • Pull display cable away from the socket.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alec Siegel

Membre depuis le 30/01/2018

505 Réputation

4 tutoriels rédigés

Équipe

Baylor, Team S2-G2, Johnson Spring 2018 Membre de l'équipe Baylor, Team S2-G2, Johnson Spring 2018

BU-JOHNSON-S18S2G2

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 3

30 derniers jours : 6

Total : 94