Introduction

In this guide, we will be showing you how to remove and replace the Display Assembly.

Pièces

Aucune pièce nécessaire.

Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in Before Working Inside Your Computer.
  • Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in Before Working Inside Your Computer.

  • Remove the mylar tapes and then remove the two screws from the back of the computer.

Ajouter un commentaire

NOTE: Note how the display cable is routed through their routing guides.
  • NOTE: Note how the display cable is routed through their routing guides.

  • Pull the display cable tab to disconnect the display cable from the system board connector.

Ajouter un commentaire

  • Make note of the cable routing and carefully dislodge the WLAN antenna cables and the rest of the cables from their routing guides. Pull the cables away, so that they are clear of the palm rest.

Ajouter un commentaire

  • Remove the two screws from either side of the display hinges.

Ajouter un commentaire

  • Lift and remove the display assembly.

Ajouter un commentaire

  • Place the NEW display assembly in place and replace the two screws on each side of the display hinges.

Ajouter un commentaire

  • Re-route and connect the display cable to the connector on the system board.

Ajouter un commentaire

  • Carefully route the WLAN antenna cables into their routing guides on the palm rest and through the computer base.

Ajouter un commentaire

Ligne d'arrivée

Terrence15

Membre depuis le 18/12/2017

69 301 Réputation

444 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 7