Introduction
In this guide, we will be showing you how to remove and replace the Display Assembly.
Ce dont vous avez besoin
-
-
Remove the screws that secure the display hinges to the palm-rest assembly and open the hinges to an angle of 90 degrees.
-
-
-
Note the antenna cable routing and remove the cable from its routing guides on the palm-rest assembly.
-
-
-
Note the display cable routing and remove the cable from its routing guides on the palm-rest assembly.
-
-
-
-
Lift the palm-rest assembly at an angle off the display assembly.
-
-
-
Place the NEW display assembly on the palm-rest assembly.
-
-
-
Close the display hinges and align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
-
-
-
Replace the screws that secure the display hinges to the palm-rest assembly.
-
-
-
Route the display cable through its routing guides on the palm-rest assembly.
-
-
-
Route the antenna cables through its routing guides on the palm-rest assembly.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.
Un commentaire
I can't replace the cables on the left side of the lid through the hinge.