Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the Laptop from the AC adapter and turn off the Laptop.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the silver 15mm PH1 screw that holds the plastic cover in place over the battery.
-
Remove the 8mm PH 1 screw that holds the plastic cover in place over the battery.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a metal jimmy, pry up to remove the first half of the cover.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Apply pressure using your fingertips on the top of the cover, pushing to the front of the laptop. This will make the plate slide off exposing the hard drive.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the three black PH1 6mm screws that anchor the hard drive.
-
This screw hole will be empty because the 15mm silver screw that holds the plastic cover will anchor the hard drive down.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the Jimmy, pry up the hard drive and lift out using your fingers.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Gently wiggle and pull the connector to disconnect the Seta Cable attaching the hard drive to the laptop.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the harness around the hard drive by removing four black 4mm PH1 screws located on the side.
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.