Pièces

Aucune pièce nécessaire.

Before removing the battery from the laptop, make sure the power is off.
  • Before removing the battery from the laptop, make sure the power is off.

  • Push both battery locking clips outward at the same time.

Ajouter un commentaire

Slide the battery out of the laptop.
  • Slide the battery out of the laptop.

Ajouter un commentaire

  • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

Ajouter un commentaire

  • Carefully turn the laptop over and open the screen all the way.

  • Locate the slot to remove the keyboard in the lower left hand corner.

  • Using a spudger as a lever, insert it into the slot and gently pry up.

Ajouter un commentaire

  • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

  • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

Ajouter un commentaire

  • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

Ajouter un commentaire

  • Remove the flexible ribbon from ZIF connector.

  • Do not pull on the ribbon to remove it from the ZIF connector.

Ajouter un commentaire

  • Position the laptop so that the bottom is facing upward.

  • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

Ajouter un commentaire

  • Return the laptop to proper position and open the screen.

  • Remove the 6 #0 4 mm screws holding in the palm rest.

Ajouter un commentaire

  • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

  • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

Ajouter un commentaire

  • Lift up on the small ZIF connector and remove ribbon.

  • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

Ajouter un commentaire

  • Remove the 4 3 mm screws that hold the cooling fan to the system board.

Ajouter un commentaire

  • Remove the tape holding the cooling fan wires down.

Ajouter un commentaire

  • Unplug the cooling fan wires from the system board by gently pulling on the hard molded plastic portion.

  • Be careful not to damage the wires by tugging on them.

Ajouter un commentaire

  • Lift the cooling fan out of the laptop.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Taylor Bateman

Membre depuis le 20/01/2012

93 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 11-20, Maness Winter 2012 Membre de l'équipe Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,194