Pièces

Aucune pièce nécessaire.

Rotate the photo printer so that the bottom of the case faces upward.
  • Rotate the photo printer so that the bottom of the case faces upward.

Ajouter un commentaire

Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.
  • Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.

Ajouter un commentaire

  • Rotate the device so that it is upright again. Under the LCD Panel there is a 9.62 mm screw, unscrew using a Phillips #2 screwdriver.

Ajouter un commentaire

  • Remove the back panel of the case by pulling directly back.

    • Some carefully applied force may be required to remove this part.

Ajouter un commentaire

  • Rotate the photo printer so that the bottom panel faces up once again. Now lift off the bottom panel of the case to access all internal components.

Ajouter un commentaire

  • Finally remove the side panel with the ink-cartridge door by holding the right side and pulling backwards with the left side.

    • Caution! The side panel is held in by tabs; don't break these.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonathan Mintz

Membre depuis le 04/04/2012

11 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 14-7, Forte Spring 2012 Membre de l'équipe Cal Poly, Team 14-7, Forte Spring 2012

CPSU-FORTE-S12S14G7

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 491