Introduction

In this repair guide you will be able to install a new mother board into the printer.

Pièces

Aucune pièce nécessaire.

Rotate the photo printer so that the bottom of the case faces upward.
  • Rotate the photo printer so that the bottom of the case faces upward.

Ajouter un commentaire

Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.
  • Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.

Ajouter un commentaire

  • Rotate the device so that it is upright again. Under the LCD Panel there is a 9.62 mm screw, unscrew using a Phillips #2 screwdriver.

Ajouter un commentaire

  • Remove the back panel of the case by pulling directly back.

    • Some carefully applied force may be required to remove this part.

Ajouter un commentaire

  • Rotate the photo printer so that the bottom panel faces up once again. Now lift off the bottom panel of the case to access all internal components.

Ajouter un commentaire

  • Finally remove the side panel with the ink-cartridge door by holding the right side and pulling backwards with the left side.

    • Caution! The side panel is held in by tabs; don't break these.

Ajouter un commentaire

  • Carefully remove the inner components of the device by lifting the inner components up and out of the casing.

Ajouter un commentaire

  • Locate the red and black cable that is connecting the fan to the top of the logic board.

Ajouter un commentaire

  • Carefully, remove the red and black cable from the logic board by pulling gently in order to isolate the cooling fan from the device.

Ajouter un commentaire

  • Locate the data ribbon that connects the LCD panel to the mother board.

  • Loosen the fasteners next to the ribbon by carefully pushing them away from the white ribbon holder.

    • Once the fasteners are loosened the ribbon should easily slide away from the motherboard.

Ajouter un commentaire

  • Locate the clips with multi-colored wires that connect the motherboard to the printing unit.

    • Disconnect both of them by gently pulling them away from the motherboard.

Ajouter un commentaire

  • Locate the white ribbon that connects the motherboard to the printing feed.

  • Disconnect the ribbon by gently pulling the ribbon away from the motherboard.

Ajouter un commentaire

  • The mother board has changed orientation. Notice the new orientation based on the white data ribbon we removed in the previous step.

  • Locate the black data ribbon that connects the mother board to the printing motors.

  • Disconnect it from the logic board, by gently pulling the wire away from the mother board.

Ajouter un commentaire

  • Now unscrew the three screws 7.89mm (counter-clockwise) using a Phillips #1 screwdriver.

Ajouter un commentaire

  • Once screws and ribbons are disconnected, you can pull mother board away from the printing unit.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cory Peterson

Membre depuis le 04/04/2012

133 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 570