Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use your T5 Torx driver to remove all eight 3.2mm hex screws holding down the back panel.
-
Wedge an opening pick between the back cover and the base of the board, then slightly lift the tool to pop the clips on the back cover off.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the bottom cover from the device when all sides are free.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the Phillips #0 screwdriver to remove all four silver 3.2mm screws fastening the interconnect cable.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully wedge the plastic opening pick between the fan and the interconnect cable.
-
Remove the interconnect cable.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the nylon tweezers to remove the interconnect pins from each of the circuit boards.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the Phillips 0 Screwdriver to carefully extract each of the four 3.2 mm screws.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Find the wire connecting the fan into the motherboard and use the plastic opening tool to push the wire out from the motherboard's port.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
The fan has been completely disconnected and is now safe to remove.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.