Introduction
Use this guide to open your 8BitDo Ultimate Wireless case.
Ce dont vous avez besoin
-
-
Insert an opening pick into the seam between the left controller grip and main controller body.
-
Pry the grip off.
-
Repeat for the right grip.
Demander à FixBot
-
-
-
Remove the six 8 mm T6 Torx screws securing the rear case to the front case.
-
-
-
-
Insert an opening tool into seam at the bottom of the device and carefully pry the front and back shells apart.
-
Set the halves next to each other with care not to strain the connected ribbon cables.
-
-
-
The ribbon cable is secured with a locking tab connector.
-
Use tweezers to unlock the locking tab on the ribbon cable connector, then gently disconnect the ribbon cable.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
