Introduction

How to open it for repairs or battery swap

The lamp opens up at the base: there are two smaller tabs next to the button, the semi-transparent plasic can be pressed in a bit with a knife, put a bit of paper inbetween to prevent the clip from snapping back. Next go with a knife towards one of the large tabs on the side until one side snaps out. Repeat for other side.
  • The lamp opens up at the base: there are two smaller tabs next to the button, the semi-transparent plasic can be pressed in a bit with a knife, put a bit of paper inbetween to prevent the clip from snapping back. Next go with a knife towards one of the large tabs on the side until one side snaps out. Repeat for other side.

Ajouter un commentaire

Remove the 4 screws (warning: 2x2 different types), out comes the pcb. Detach battery connector at the back.
  • Remove the 4 screws (warning: 2x2 different types), out comes the pcb. Detach battery connector at the back.

Ajouter un commentaire

  • remove two more screws to get at the battery

Ajouter un commentaire

  • Overview of parts

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

petur

Membre depuis le 23/07/2011

178 Réputation

2 tutoriels rédigés

I think it is easier to open the lamp by pressing the semi-transparent part at the opposite side of the button.

Matthieu Morel - Réponse

How can I open the lamp??? Please post a photo of how are u using the knife because I can't!!!

Alberto Santaella Gallego - Réponse

you need to press the clips inward, the picture shows where the clips are. Slide inbetween and press

petur - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 18

Total : 1,761