Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

This guide describes the steps to opening the case.

Pièces

Aucune pièce spécifiée.

  1. Remove 2 screws from each side of the amplifier.
    • Remove 2 screws from each side of the amplifier.

  2. Remove 2 screws on rear of device. Slide top cover up and back from main case.
    • Remove 2 screws on rear of device. Slide top cover up and back from main case.

  3. Manta Precision Bit Set

    112 embouts pour toute réparation.

    Upgrade Your Toolbox

    Manta Precision Bit Set

    Upgrade Your Toolbox
  4. Remove 3 screws on bottom of case. Remove 13 screws on rear panel.
    • Remove 3 screws on bottom of case.

    • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

  5. Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.
    • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

    • It may require some wiggling, but it should slip out of the hole and then off of the cord.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Colby

Membre depuis le 15/04/2010

284 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 28-36, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-36, Regan Spring 2010

CPSU-REGAN-S10S28G36

4 membres

3 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 3,485