Introduction

Use this guide to repair a broken battery door. The battery door on this model tends to break off due to a weak plastic hinge.

Pièces

Aucune pièce nécessaire.

  1. Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
    • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

    Ajouter un commentaire

  2. On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
    • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

    • Pry up the panel; starting from the front/bottom corner, as indicated.

      • There's a concealed lip, under the opposite edge.

    Ajouter un commentaire

    • Remove three medium length screws from the bottom of the camera

    Ajouter un commentaire

    • Remove the two medium length screws on the front panel of the camera above the lens mount.

    • Once you done, you may use the Spudger to panel from non-grip side.

    • If you start on the grip side, it will be more challenging to loosen the panel.

    Ajouter un commentaire

    • Remove the two 4.5mm (.18in) long black screws from the camera grip using a #00 Phillips screwdriver.

    Ajouter un commentaire

    • Use your fingertip to pry off the external shutter port cover.

    Ajouter un commentaire

    • Remove the two 5mm (.20in) long silver screws securing the grip to the camera using a #00 Phillips screwdriver.

    Ajouter un commentaire

    • Use the spudger tool to carefully pry the grip from the rest of the camera.

    Ajouter un commentaire

    • Once the grip is loose, use your fingers to remove it from the camera.

    Ajouter un commentaire

    • Remove the 4.8mm (.19in) long silver screw from the inside of the grip.

    Ajouter un commentaire

    • Remove the hinge of the battery door from the inside of the grip.

    • Our sample camera's battery door was broken off of its hinge. Picture two shows an example of a battery door that is not broken.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel Bussone

Membre depuis le 28/01/2011

1 215 Réputation

11 tutoriels rédigés

Équipe

Cal Poly, Team 3-41, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 10

Total : 4,040