Introduction

Use this guide to remove the front and rear cover of the Canon PowerShot SD1100 IS.

Pièces

Aucune pièce nécessaire.

Remove wrist strap and battery.
  • Remove wrist strap and battery.

Ajouter un commentaire

Remove 2 screws from each side of the camera (4 total, 0.102 in).
  • Remove 2 screws from each side of the camera (4 total, 0.102 in).

  • Remove 2 screws from the bottom on the camera (0.138 in).

  • Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

Ajouter un commentaire

  • Gently pull off the front cover.

  • The plate on the side should come off.

  • Gently pull off the back cover.

Ajouter un commentaire

  • The cases should now be removed.

This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

Craig Bonsignore - Réponse

oh yes , i agree lol

elbala80 -

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Tyler Grossheim

Membre depuis le 25/01/2011

1 359 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 3-32, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 3-32, Regan Winter 2011

CPSU-REGAN-W11S3G32

3 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 3,141