Introduction

Removing the front cover allows access to the flash assembly.

Pièces

Aucune pièce nécessaire.

  1. Remove one 2.25mm screw on the bottom.
    • Remove one 2.25mm screw on the bottom.

  2. Remove two 2.25mm screws on the right side looking from the front.
    • Remove two 2.25mm screws on the right side looking from the front.

  3. Remove one 4.7mm screw on the side with the AV output.
    • Remove one 4.7mm screw on the side with the AV output.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Pull off the back cover.
    • Pull off the back cover.

    • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

  6. Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.
    • Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.

  7. Remove one 2.25mm screw on the bottom of the camera.
    • Remove one 2.25mm screw on the bottom of the camera.

  8. Pull off the front cover.
    • Pull off the front cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Membre depuis le 10/10/2010

135 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 20-9, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 2,288