Introduction

Wireless module in your way? Move it out!

Pièces

Aucune pièce nécessaire.

Find the battery and the battery tabs located on the bottom of the Compaq Mini.
  • Find the battery and the battery tabs located on the bottom of the Compaq Mini.

Ajouter un commentaire

Push the tabs inward and slide the battery out.
  • Push the tabs inward and slide the battery out.

Ajouter un commentaire

  • Find and remove the two screws on the bottom of your Compaq Mini covering the memory compartment.

    • Note that the screws are attached to the panel.

Ajouter un commentaire

  • Push out side tabs.

Ajouter un commentaire

  • Remove the rubber pads located on the corners of your Compaq Mini.

  • There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Ajouter un commentaire

  • Unscrew all the corner screws. There are four total, one under each rubber pad.

Ajouter un commentaire

  • Unscrew the screw for the bottom case located in the RAM compartment.

Falta um passo, pois nos modelos COMPAQ MINI 110, existe um parafuso que segura o teclado, que se encontra bem escondido dentro da cavidade que encaixa a bateria.

Amilcar Correia - Réponse

  • Remove the three screws in the silver tabs at the back of the keyboard. The red circles show where they are located at the back of the base under the screen.

3 screws in red circles are actually on metal tabs in the battery compartment, 1 deeper than the other 2. There is a keyboard symbol for each of the 3 screws.

Step 8B: Lift out keyboard by pushing upwards on the 2 accessible metal tabs. This is the most difficult step. Lack of Quality Control during assembly may prevent the kevboard from lifting out without breaking!!

John - Réponse

This step may be performed after battery removal. Use care when removing ribbon cable: the white clips holding the black plastic "keeper" are fragile. Reassembly possible without white clips; however, jostling may cause the ribbon to come free.

Jason L - Réponse

  • Remove the three screws.

Ajouter un commentaire

  • Pull up on the tab.

Ajouter un commentaire

  • Remove the eight screws from the plastic top cover.

Ajouter un commentaire

  • Pry up the top plastic cover using a spudger.

    • Under the screen there are two tabs that need to be pushed in.

Ajouter un commentaire

  • Careful lifting up the cover because the track pad is still attached.

  • Remove the cable by pulling it up.

Ajouter un commentaire

  • Remove the two screws holding the module in place.

Ajouter un commentaire

  • Detach the two wires.

Ajouter un commentaire

  • Just pull it out.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

alea

Membre depuis le 06/10/2010

1 260 Réputation

14 tutoriels rédigés

Équipe

Cal Poly, Team 22-2, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 22-2, Maness Fall 2010

CPSU-MANESS-F10S22G2

6 membres

20 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 12

Total : 3,921