Introduction

How to open up and remove the internal hard drive and board.

  1. Remove screw to access hidden top tab.
    • Remove screw to access hidden top tab.

    • Use a point like tool to press the two tabs around the USB 3 connector. These are accessible via the holes arrowed.

    • You can slightly lift the back edge up to help free the tabs as you press them in a little, not a lot, doesn't take much to release them.

    Ajouter un commentaire

  2. Along the top are two tabs.  Using a thin bladed screw driver, insert to catch and pull back the tab slightly.
    • Along the top are two tabs. Using a thin bladed screw driver, insert to catch and pull back the tab slightly.

    • Lift on the cover slightly to help release the tabs.

    Ajouter un commentaire

    • Front of the case has two tabs.

    • Continuing gently lifting on the cover while releasing the hidden tabs.

    Ajouter un commentaire

    • Again, insert flat blade screwdriver while lifting on the cover.

    Ajouter un commentaire

    • Hard drive exposed

    • Use the flat blade screwdriver to gently pry out the led plastic light tube from the case.

    • Hard drive is only held in with rubber bumper style mounts and will come out with a little finger pulling.

    Ajouter un commentaire

    • Remove drive from case and flip over and remove the two screws.

    • You will be left with the board and interface, ready to install new drive.

    • Installation is the reverse of removal! Enjoy!

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

8 autre(s) ont terminé cette réparation.

HWgeek

Membre depuis le 03/12/2012

267 Réputation

1 tutoriel rédigé

Nice, easy and concise ‘how-to’. You made my task so much easier. Thank you!

Brian Puffer - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 37

30 derniers jours : 127

Total : 15,083