Aller au contenu principal

Introduction

This guide shows how to fully disassemble a Garmin Nuvi 1200 to replace the logic board.

Pièces

Aucune pièce spécifiée.

  1. Remove to sticker on the back of the unit and then remove the two T5 scremws once this is done use a spudger to carefully pry off the silver cover.
    • Remove to sticker on the back of the unit and then remove the two T5 scremws once this is done use a spudger to carefully pry off the silver cover.

    • Once the tool is inserted it can slide around the entire device.

  2. Remove four small T5 torx screws.
    • Remove four small T5 torx screws.

    • Be gentle, the screws are easily stripped.

  3. Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now

    Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now
  4. Lift cover off of unit. Be careful not to lose small rubber piece on the bottom right corner.
    • Lift cover off of unit.

    • Be careful not to lose small rubber piece on the bottom right corner.

  5. Disconnect ribbon cable from logic board.
    • Disconnect ribbon cable from logic board.

  6. Remove two T5 torx screws holding down logic board.
    • Remove two T5 torx screws holding down logic board.

    • Disconnect battery.

  7. Gently lift the logic board out of the unit
    • Gently lift the logic board out of the unit

    • Be careful not to damage the battery connector on the top of the unit.

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Zachary Landau

Membre depuis le 28/11/2010

178 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 4,970