Introduction

In order to gain access to most of the internal components the top (or lid) of the printer must be removed. This guide is intended as a prerequisite for other installations.

Pièces

Aucune pièce nécessaire.

Open the front access panel by placing your finger in the front slot and pulling gently.
  • Open the front access panel by placing your finger in the front slot and pulling gently.

Ajouter un commentaire

Open the protective lid that is covering the glass. Press gently against the base of the panel to remove the lid from the rest of the printer.
  • Open the protective lid that is covering the glass. Press gently against the base of the panel to remove the lid from the rest of the printer.

Ajouter un commentaire

  • Remove the four 9mm T10 Torx screws on the top.

Ajouter un commentaire

  • Carefully lift the top panel off of the printer.

  • Do not tear or damage the two cables that connect the top lid to the motherboard.

Ajouter un commentaire

  • Remove the two cables by gripping each one close to their connection ports on the motherboard and gently disconnecting them.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

16 autre(s) ont terminé cette réparation.

Tim

Membre depuis le 15/01/2013

134 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 18-35, Regan Winter 2013 Membre de l'équipe Cal Poly, Team 18-35, Regan Winter 2013

CPSU-REGAN-W13S18G35

5 membres

8 tutoriels rédigés

I want fix my HP DESKJET F448o, My problem is, that the scanner arm is block.

When I turn on, the scanner arm is block, how can fix its?

mbeto0351 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 4

7 derniers jours : 20

30 derniers jours : 78

Total : 6,156