Pièces

Aucune pièce nécessaire.

  1. Turn off the camera.
    • Turn off the camera.

      • Locate the power switch on the front of the camera below the camera lens.

      • Slide the switch to the off position.

    Ajouter un commentaire

  2. Locate the 3 screws that hold the back cover to the camera.
    • Locate the 3 screws that hold the back cover to the camera.

      • One screw is located on the film opener side of the camera.

      • The other screws are located on the opposite side of the camera.

    Ajouter un commentaire

    • Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.

    Ajouter un commentaire

    • Open the film door to remove the back cover.

      • Slide the film door lever to the left until the film door opens.

    Ajouter un commentaire

    • Use a plastic opening tool to pry the case open until a small gap is present.

      • Repeat this process at the top and bottom of the film door to loosen it.

    Ajouter un commentaire

    • Grab the top and bottom of the case firmly as shown.

      • Gently remove the back of the camera case with a slight twisting motion.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Cottrell

Membre depuis le 04/10/2011

58 Réputation

5 tutoriels rédigés

Équipe

UW Stout, Team 1-2, Zhou Fall 2011 Membre de l'équipe UW Stout, Team 1-2, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G2

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 428