Pièces

Aucune pièce nécessaire.

  1. The back panel (pictured left) has a black wire (end of wire circled red).  The wire solders to the bottom right corner of the card drive.
    • The back panel (pictured left) has a black wire (end of wire circled red). The wire solders to the bottom right corner of the card drive.

    • The front panel (pictured right) has a black and red wire (end of wired circled green). This wire solders to a small circular spot next to where the black wire connects to the back (from above).

  2. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
Conclusion

To reassemble your device, follow these instructions in reverse order.

ewkpates

Membre depuis le 03/05/2012

123 Réputation

1 tutoriel rédigé

To open the leappad top start with, remove battery covers and the 6 screws.

The two halves slide, bottom half towards cartridge slot, to make it harder they have used double sided tape on the bottom platic tounges, so a scredriver in the bottom will be needed to prize the slide.

Lawrence - Réponse

Good stuff. I'm trying to slide the back plate upward, but to no avail. You mentioned tape. Where exactly is it located?

John - Réponse

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 5,557