Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.
Introduction
The Macintosh IIsi Uses a 120/240V AC Power Supply. It provides power directly to the logic board. From there, it is distributed to the rest of the computer.
Ce dont vous avez besoin
-
-
The "SuperDrive" is mounted similarly to the hard drive, and positioned right next to it.
-
Push these two tabs out, and lift the drive up.
-
-
-
-
The fan recieves power from two contacts on the logic board and has no connector.
-
-
-
In all of the years that I have worked on this machine, I have found no good way to remove the fan.
-
The best way to start, is to push in here on the side of the fan.
-
Being careful not to exert too much force, try to push in, and wiggle the fan outward as such. (2nd Photo)
-
You can now lift the fan all the way out, and remove it.
-
The Fan Power Contacts on the Logic Board:
-
-
-
To remove the power supply, squeeze these two tabs and lift the front up.
-
On the back of the power supply, there is a tab that also must be pressed to remove the power supply fully. You can then lift it out all the way. A firm tug may be necessary to seperate the power connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Équipe
