Aller au contenu principal

Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.

Disassembling Nintendo DS Lite Lower Screen

Ce dont vous avez besoin

  1. Disassembling Nintendo DS Lite Lower Screen, Nintendo DS Lite Battery Disconnect: étape 1, image 1 de 1
    • Place your device upside down and locate the battery compartment.

    • Find the Phillips head screw securing the battery cover in the bottom right hand corner of the device.

    • Loosen the screw enough to remove the battery cover but leave the screw in the cover for reassembly.

    • Use only a Phillips screwdriver to remove screw.

  2. Disassembling Nintendo DS Lite Lower Screen: étape 2, image 1 de 1
    • Slowly remove the battery cover with the iFixit opening tool.

    • Make sure to remove the cover carefully to keep from losing Phillips screw in the cover. It will be needed for reassembly.

  3. Disassembling Nintendo DS Lite Lower Screen: étape 3, image 1 de 2 Disassembling Nintendo DS Lite Lower Screen: étape 3, image 2 de 2
    • Use the iFixit opening tool to carefully pry the battery out of the case.

    • After the old battery is removed replace it with a new battery facing the same direction as when the cover was opened.

    • For some devices, you may be able to remove the battery by flipping the DS over and letting the battery fall into your hand.

  4. Disassembling Nintendo DS Lite Lower Screen, Disassembling Nintendo DS Lite Bottom Case: étape 4, image 1 de 1
    • Remove the following seven screws that secure the lower case to the DS Lite:

    • Three silver tri-wing screws (5mm long)

    • One black tri-wing screw (4mm)

    • Two gold Phillips screws (4mm)

    • One silver Phillips screw (3mm)

    • Do not remove the silver PH screw (3mm) in the battery compartment yet. It holds the main PCB in place.

  5. Disassembling Nintendo DS Lite Lower Screen: étape 5, image 1 de 1
    • On the front edge of the Nintendo DS between the headphone jack plug and volume controls remove the plastic insert (or cartridge) from the lower slot (Slot 2).

  6. Disassembling Nintendo DS Lite Lower Screen: étape 6, image 1 de 2 Disassembling Nintendo DS Lite Lower Screen: étape 6, image 2 de 2
    • Flip the unit over so that it is facing right-side up.

    • Use a spudger to pry open the gap between the bottom case and the front panel. Work all the way around the case until the panel is free.

    • Avoid touching the L and R shoulder buttons, because they easily detach and are difficult to reassemble. Keep the bottom case flat against your workbench to help hold the shoulder buttons in place.

  7. Disassembling Nintendo DS Lite Lower Screen: étape 7, image 1 de 3 Disassembling Nintendo DS Lite Lower Screen: étape 7, image 2 de 3 Disassembling Nintendo DS Lite Lower Screen: étape 7, image 3 de 3
    • Carefully separate the two pieces by hand.

    • The two shoulder buttons are made up of three pieces -- the plastic button, a pin, and a spring. If they accidentally pop out while you are working, study the picture and make sure you put the spring in the correct position.

    • When reassembling the cover, make sure that the power switch caver on the bottom case is in the off (down) position to avoid breakage.

  8. Disassembling Nintendo DS Lite Lower Screen, Disassembling Nintendo DS Lite Lower Screen: étape 8, image 1 de 1
    • After taking the back panel off, locate and unscrew the two screws holding the logic board to the rest of the device.

  9. Disassembling Nintendo DS Lite Lower Screen: étape 9, image 1 de 2 Disassembling Nintendo DS Lite Lower Screen: étape 9, image 2 de 2
    • Locate the small ribbon cable that connects the touch screen to the logic board. Do not pull on this cable.

    • Gently lift the hinged black cover on the connector.

    • The hinges are near where the ribbon is inserted.

    • After lifting the black cover, the ribbon cable will disconnect easily.

  10. Disassembling Nintendo DS Lite Lower Screen: étape 10, image 1 de 1
    • With a plastic opening tool, gently begin to separate the logic board from the rest of the device.

    • The ribbon cable and two wires are still connected to the logic board and the buttons tend to fall out.

  11. Disassembling Nintendo DS Lite Lower Screen: étape 11, image 1 de 2 Disassembling Nintendo DS Lite Lower Screen: étape 11, image 2 de 2
    • Flip logic board over so touch screen is facing up.

  12. Disassembling Nintendo DS Lite Lower Screen: étape 12, image 1 de 1
    • Do not pull on the main ribbon cable.

    • Carefully lift the tiny hinged cover on the connector.

    • The ribbon cable will easily disconnect.

    • Remove the third ribbon cable the same way.

  13. Disassembling Nintendo DS Lite Lower Screen: étape 13, image 1 de 1
    • There is nothing else connecting the touch screen. Just pick up and set aside.

Ligne d'arrivée

6 autres ont terminé cette réparation.

justin chadwick

Membre depuis le 01/21/10

397 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 16-30, Maness Winter 2010 Membre de l'équipe Cal Poly, Team 16-30, Maness Winter 2010

CPSU-MANESS-W10S16G30

4 membres

24 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 18

7 derniers jours : 90

30 derniers jours : 325

Total : 15,584