Aller au contenu principal

Introduction

This guide provides instructions for disassembling a broken LCD screen on the Olympus Stylus 725.

Pièces

Aucune pièce spécifiée.

  1. The battery is located on the bottom of the camera. Remove the battery by placing your thumb on the buttom flap and sliding the release button away from the side the lens is on. (The screwdriver is simply used as a reference point, no screws need to be removed)
    • The battery is located on the bottom of the camera.

    • Remove the battery by placing your thumb on the buttom flap and sliding the release button away from the side the lens is on. (The screwdriver is simply used as a reference point, no screws need to be removed)

    • Charge the battery for 60-90 minutes if your battery is dead.

    • When installing a charged battery, align the battery appropriately, with the positive signs and negative signs lining up.

  2. Unscrew the 3mm long cover screws at the corners of the camera using a #00 Philips Screwdriver. Unscrew the 2mm long screws securing the sides of the camera which holds the back panel. Use the same screwdriver. Unscrew the 2mm long screws securing the sides of the camera which holds the back panel. Use the same screwdriver.
    • Unscrew the 3mm long cover screws at the corners of the camera using a #00 Philips Screwdriver.

    • Unscrew the 2mm long screws securing the sides of the camera which holds the back panel. Use the same screwdriver.

  3. Be careful when removing the back cover, you will need to detach the connecting ribbons Detach the ribbons using your thumb, sliding them out of their slots.
    • Be careful when removing the back cover, you will need to detach the connecting ribbons

    • Detach the ribbons using your thumb, sliding them out of their slots.

  4. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  5. Use a #00 Phillips head screwdriver to remove the screws in the back panel. After removing the back panel,  slide the ribbons off the computer chip to detach them. After removing the back panel,  slide the ribbons off the computer chip to detach them.
    • Use a #00 Phillips head screwdriver to remove the screws in the back panel.

    • After removing the back panel, slide the ribbons off the computer chip to detach them.

  6. Use tweezers to remove the loosened LCD screen. Be careful to not scratch the new LCD screen when replacing it.
    • Use tweezers to remove the loosened LCD screen.

    • Be careful to not scratch the new LCD screen when replacing it.

    • Carefully place the new screen in place of the old, making sure the label faces up.

    • Slide the ribbons back onto the computer chip.

    • Using the #00 Phillips head screwdriver from before, screw the screws in the back into the panel.

Conclusion

Be sure to test the device by turning it on once the screen has been replaced. Make sure that the new screen works properly.

Une autre personne a terminé cette réparation.

Bobby Hodges

Membre depuis le 18/04/2010

49 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 33-71, Johann Spring 2010 Membre de l'équipe Cal Poly, Team 33-71, Johann Spring 2010

CPSU-JOHANN-S10S33G71

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 14

Total : 7,608