Introduction

Separating the logic board from the face plate.

Pièces

Aucune pièce nécessaire.

  1. Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.
    • Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.

    Ajouter un commentaire

  2. Remove the top screw on the back panel.
    • Remove the top screw on the back panel.

    Ajouter un commentaire

    • Slide off the case to expose the internal components of the receiver.

    Ajouter un commentaire

    • Unscrew the three screws on top of the face plate.

    Ajouter un commentaire

    • Unscrew the one screw on the bottom of the front panel.

    Ajouter un commentaire

    • Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force.

    Ajouter un commentaire

    • On the inside middle of the face plate you will see two screws in the logic board. Unscrew these two screws.

    Ajouter un commentaire

    • You will see the same snaps along the top of the logic board. Press the heads of the snaps down and pull the logic board out and up.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ryan

Membre depuis le 13/04/2010

86 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 27-92, Amido Spring 2010 Membre de l'équipe Cal Poly, Team 27-92, Amido Spring 2010

CPSU-AMIDO-S10S27G92

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 2,160