Introduction

This guide will instruct you to take the left cover off of the camcorder.

  1. Remove the 6-7.9mm ph#0 screws on the back and bottom.
    • Remove the 6-7.9mm ph#0 screws on the back and bottom.

    • Remove the one 3.8mm ph#0 screw on the bottom.

    • Remove the two 7.5mm ph#0 screws on the back and bottom.

    Ajouter un commentaire

  2. Remove 5.8mm ph#1 screw from the side button panel.
    • Remove 5.8mm ph#1 screw from the side button panel.

    • Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.

    Ajouter un commentaire

    • Pry along the seam on the top side near the buttons with a spudger.

    Ajouter un commentaire

    • Pull the left panel away from the rest of the camcorder.

    • Unplug the red speaker cable located at the rear of the device.

    • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ashley Katchadourian

Membre depuis le 20/01/2011

112 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 5-20, Amido Winter 2011 Membre de l'équipe Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 592