Aller au contenu principal

Introduction

This guide is to remove the base plate. This will allow you to access the rest of your saw and disassemble it properly.

Pièces

Aucune pièce spécifiée.

  1. Orient your saw so that the blade is pointing in the opposite direction of your body. Ensure that the screws circled are visible and pointing skyward. This will be the standard position of the Jigsaw for the duration of this guide. Orient your saw so that the blade is pointing in the opposite direction of your body. Ensure that the screws circled are visible and pointing skyward. This will be the standard position of the Jigsaw for the duration of this guide. Orient your saw so that the blade is pointing in the opposite direction of your body. Ensure that the screws circled are visible and pointing skyward. This will be the standard position of the Jigsaw for the duration of this guide.
    • Orient your saw so that the blade is pointing in the opposite direction of your body. Ensure that the screws circled are visible and pointing skyward. This will be the standard position of the Jigsaw for the duration of this guide.

  2. Using two hands grip both side of the saw and lay on side.
    • Using two hands grip both side of the saw and lay on side.

  3. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  4. With bottom of the base plate visible, identify one M4 screw circled in red and remove with Phillips screwdriver (some models have flathead screw, as pictured, and require flathead screwdriver).
    • With bottom of the base plate visible, identify one M4 screw circled in red and remove with Phillips screwdriver (some models have flathead screw, as pictured, and require flathead screwdriver).

  5. After removing M4 screw, remove the base plate and place to the side. Don't forget to replace the M4 screw near the base plate during re-installation.
    • After removing M4 screw, remove the base plate and place to the side. Don't forget to replace the M4 screw near the base plate during re-installation.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Adam Cardoso

Membre depuis le 12/11/2013

330 Réputation

3 tutoriels rédigés

Équipe

UMass Dartmouth, Team 4-8, Vijaybhaskar Fall 2013 Membre de l'équipe UMass Dartmouth, Team 4-8, Vijaybhaskar Fall 2013

UMASSD-VIJAYBHASKAR-F13S4G8

3 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 9

30 derniers jours : 24

Total : 1,584