Danger
Potentiellement dangereux
Risque de blessure si cette procédure n'est pas suivie correctement. Faites preuve de prudence et suivez tous les avertissements.
Danger

Introduction

My autofocus bearings were stopped, I could focus only between min to 0.5m. This will show how to reach a part which moves the lens and makes it to zoom and focus.

Done by Rimvydas Gudeliauskas

Outils

Pièces

Aucune pièce nécessaire.

  1. Take the lens away from camera
    • Take the lens away from camera

    • DO NOT FORGET: THAT YOU ARE DOING ALL ON YOUR OWN RESPONSIBILITY

    Ajouter un commentaire

  2. Unscrew the top part and detach it.
    • Unscrew the top part and detach it.

    • Unjoin cables. Be careful; they're delicate, and easily torn.

      • Try to avoid contact with the sensitive electronic components.

    • Unfasten the screws that hold the circuit board in place, and separate it from the rest of the lens assembly.

    Ajouter un commentaire

    • Take away zoom rubber and you will find srews

    Ajouter un commentaire

    • Just take parts you need until you reach what you want to fix

    • Zoom bearing can be taken away by unscrewing its srews.

    Ajouter un commentaire

    • Here is one of the parts which was broken, so I go to camera repair shop, and bought that parts. As this was not the only part broken, I had to leave for additional repair.

    • When you finish you can put all back together

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

Rimvydas

Membre depuis le 29/03/2012

296 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 31

30 derniers jours : 135

Total : 24,620